Fluoroloy® A12 Material
Features and Benefits
- Excellent wear and heat resistance
- Non-abrasive
- Recommended for moderate to high speed service running against soft or hard metals
- Performs well against lubricated and non-lubricated surfaces
Working Temperature Range | Color |
| -450° to +550°F | Light Brown |
| [-268° to +288°C] | |
Typical Physical Property Values
Properties1 | ASTM | Units [Metric] | Value [Metric] |
| Physical Specific Gravity |
D792 | -- |
1.95 |
| Mechanical Tensile Strength |
D1708 |
PSI [MPa] |
2,000 [13.8] |
| Elongation | D1708 | % | 180 |
| Compression Strength2 | D695 | PSI [MPa] | 1,000 [6.89] |
| Deformation Under Load3 | D621 | % | 3 |
| Hardness | D2240 | Shore D | 60 |
| Coefficient of Friction | D3702 | -- | 0.12 |
| Thermal Thermal Conductivity | D435 |
cal/(cm-sec °C) [BTU-in(hr-ft2 °F] |
5.9 x 10-4 [1.7] |
| Flammability | D635 | in./min. | Non-flammable |
| Electrical | | | |
| Dissipation Factor | D150 | Frequency = 1MHz | 0.015 |
| Dielectric Constant | D150 | Frequency = 1MHz | 2.4 |
| Dielectric Strength | D149 | V/mil | > 200 |
| Surface Resistivity | D4496 | Ω | 6.3 x 1018 |
| Volume Resistivity | D4496 | Ω-cm | 8.2 x 1018 |
1 All testing is performed at room temperature unless otherwise specified
2 Compression Strength was tested at !% strain
3 Deformation Under Load was tested at 2,000 PSI [13.8 MPa] for 24 hours
Note: The data listed falls within the normal range of properties, but should not be used to establish specification limits nor used solely as the basis of design. Saint-Gobain Performance Plastics assumes no obligation or liability for any advice furnished by the Company or for results obtained with respect to the products.